I am installing 2 WLCs (AIR-WLC4402-50-K9) and 15 AIR-LAP1242AG-A-K9 to replace the existing wireless network which is made of standalone APs (AIR-AP1230B-A-K9). The current wireless users are on VLAN 308. This VLAN has 2 subnets: primary (184.108.40.206/26) and secondary (220.127.116.11/25) as follows:
interface Vlan308 description Wireless Catalyst System ip address 18.104.22.168 255.255.255.128 ip address 22.214.171.124 255.255.255.192 secondary
The secondary subnet was added to VLAN 308 due to lack of IPs available on the primary subnet to attend all the wireless users.
I am configuring the interface called “ap-client” as follows:
Interface Name VLAN Identifier IP Address Interface ap-client308148.95.208.X
I have two questions about this environment?
The first question is:
1)Will wireless users be able to be assigned to the secondary subnet of this VLAN (126.96.36.199/25)? Or will the wireless client only be assigned to the primary subnet (188.8.131.52/26)?
This site has 26 standalone APs and in the first phase of the project only 15 APs will be replaced by LWAPPs, the remaining 11 standalone APs will have to coexist with the LWAPPs for some time until the second phase of the project, when the remaining 11 APs will be up migrated to LWAPPs
The second question is:
2)Is it possible to for a WLC and a standalone environment to coexist?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...