We are setting up our UWN for location, when installing a building floor into the WCS we are having issues with the image quality.
Although the WCS will display the map correctly in the floor view, when we try to open it using the map editor, the image pixilation and the quality is very poor so we are unable to correctly add the obstacles.
If we try to add an image with a higher DPI the image quality becomes worse.
Are there any recommendations for importing a map into the WCS for this purpose?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...