Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wireless Controller 2504 - Monitoring using SNMP

Hi everyone!

We're implementing a new monitoring system in our company that uses SNMP as "monitor engine".

We have 9 AP's connected in the Cisco Wireless Controller 2504 and I want to know if is it possible monitor the following itens through SNMP or CLI (script):

a-) Number of connected AP's on the controller.

b-) Number of users connected in each WLAN

c-) State (up or down) of each AP connected on the Controller

I've searched in many forums and honestly I didn't find anyone with this kind of scenario. I'm still looking for an OID but I really believe that this metrics are not avaialble using SNMP as a monitoring protocol.

If you say that this informations are visible using CLI, maybe I can create a script for each counter, but I didn't find any command that bring these informations.


André Mascarenhas