Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless Controller 4402

Hi,

I have a cisco wireless controller 4402 with 1020 LWAPP access points install. I did an upgrade of the software to 5.2.178.0 today. I got and error and reset the sytem. Forgetting that the access points may have been updating their software. Now i cannot detect any access points. Is there anyway to get the access point to communicate with the controller again?

Thanks

4 REPLIES
New Member

Re: Wireless Controller 4402

I don't think that 5.2 supports the 1000 series APs.

Hall of Fame Super Gold

Re: Wireless Controller 4402

"Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 5.2.178.0

February 10, 2009

Note Unlike controller software release 5.2.157.0, the 5.2.178.0 release is supported for use in Japan.

These release notes describe open and resolved caveats for software release 5.2.178.0 for Cisco 2100 and 4400 Series Wireless LAN Controllers; Cisco Wireless Services Modules (WiSMs); Cisco Wireless LAN Controller Network Modules; Catalyst 3750G Integrated Wireless LAN Controller Switches; Cisco 3201 Wireless Mobile Interface Cards (WMICs); Cisco Aironet 1100, 1130, 1140, 1200, 1230AG, 1240, 1250, 1300, and AP801 Series Lightweight Access Points; and Cisco Aironet 1130AG, 1240AG, 1522, and 1524 Mesh Access Points, which comprise part of the Cisco Unified Wireless Network (UWN) Solution."

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn521780.html#wp118503

New Member

Re: Wireless Controller 4402

Hi Adrian,

The 1000 series lightweight access points are not supported with the 5.2.x software image.In fact 1000 series APs are not supported from 5.0.148 onwards.

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn501480.html#wp304482

Now, you need to check on the controller.If the current software version is 5.2.178.0 then it will obviously not detect 1000 series APs.If the image on the WLC is something prior to 5.0.148.0 let me know so that we can try some other steps.

Cheers,

Manish

New Member

Re: Wireless Controller 4402

It was the 5.2 version. I downgraded to 4.1.192.35M and the wireless controller detected the 1000 series

Thanks for all the help

Regards,

Adrian

323
Views
0
Helpful
4
Replies