06-24-2009 08:33 AM - edited 07-03-2021 05:45 PM
Hello! I have a wireless controller 4404, running 4.2.176.0 code. I have LAG enabled but currently have only 2 ports used, I am planning on connnecting the other two ports soon. Will this cause an outage? I am thinking no, but I want to see if anyone has ever done this and what the outcome was. Thank you.
06-24-2009 04:25 PM
Are you plugging the last 2 uplinks to the same switch?
Just make sure that STP is DISABLED and it should be fine.
06-25-2009 07:54 AM
Yes I am plugging the last two uplinks to the same switch, but on a different module. When you say make sure that STP is disabled, what are you referring to? Spanning-tree portfast?
06-25-2009 03:41 PM
Yes. Just make sure STP Portfast is disabled.
06-26-2009 04:40 AM
Also make sure you create an ap-manager interface for every active port on the controller.
06-27-2009 11:39 AM
LAG is enabled so there will only be one AP Manager interface. No requirement/ability to create additional interfaces.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: