Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless Controller, clients in VLAN1

I have a network, everything in VLAN1 (I know this is not good, but for the moment, I like to keep it that way) I installed a WLC 4402, but I cant seem to get my wireless clients in the same VLAN as the controller. Is this normal? Is there a way around? Thank You

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Wireless Controller, clients in VLAN1

I have done this without any issues in a flat network. You do not need to create any new interfaces since it is flat. In your wireless lan SSID, use the management interface as its interface. If the VLAN is flat, make sure the VLAN identifier is 0. Hope this helps.

2 REPLIES
New Member

Re: Wireless Controller, clients in VLAN1

I have done this without any issues in a flat network. You do not need to create any new interfaces since it is flat. In your wireless lan SSID, use the management interface as its interface. If the VLAN is flat, make sure the VLAN identifier is 0. Hope this helps.

New Member

Re: Wireless Controller, clients in VLAN1

Yes this works. Thx

106
Views
0
Helpful
2
Replies