We have implemented a single 350 AP with Cisco ACS 2.6. The problem is that the clients are able to associate and logon through the radius server, but never receive an ip address. The clients are W2K and XP. Any thoughts on what the problem might be or how to configure the radius server properly to give out ip's to the wireless clients?
One thing to check is that if you are using WEP with LEAP then you need to make sure that the keys are the same on the client and the AP. Try upgrading the firmware on the AP as this can be an issue for DHCP.
Thank you for your reply. However, I have discovered the problem. The access point had the aironet extensions disabled, but MIC and TKIP were configured and enabled. This was preventing me from communicating properly. As soon as I enabled the aironet extensions, things started to work properly.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...