Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Wireless - Mobility Anchor - Data Path / Control Path

Hi,

Wireless - Mobility Anchor - Data Path / Control Path

We had to power down the 2 WLC , Primary - 5508 / Mobility Anchor - 2504

Now the Control path is up for the Guest Wireless , however Data path refuses to come up.

I tried removing and dding the mobility anchor. no go.

tried enabling / disabling the interface / SSID - no go.

has any one faced this kind of issue before. We not made any changes to the configs.

Thanks,

JA

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Maybe the config was not

Maybe the config was not saved of something happened.... I would look at the mobility configuration again... make sure the mac address you use is the one that shows up on the first line when adding a mobility group.  This should match up with the WLC base mac address, but at times it doesn't.  

I would also monitor your FW to see if the FW is blocking udp 16666 and udp 16667 (mping/control path) or IP 97 (eping/data path)

-Scott
*** Please rate helpful posts ***
3 REPLIES
Cisco Employee

how about Mping ? also can

how about Mping ?

 

also can you share show run-config , from both WLCs ?

Hall of Fame Super Silver

Maybe the config was not

Maybe the config was not saved of something happened.... I would look at the mobility configuration again... make sure the mac address you use is the one that shows up on the first line when adding a mobility group.  This should match up with the WLC base mac address, but at times it doesn't.  

I would also monitor your FW to see if the FW is blocking udp 16666 and udp 16667 (mping/control path) or IP 97 (eping/data path)

-Scott
*** Please rate helpful posts ***
Community Member

hi  thanks for your replies

hi 

 

thanks for your replies.

the issue was with our firewalls on the inside interface. I disabled it for a moment and it was ok. and then re-enabled the firewall rules it was still ok. Maybe it was just a few packets required to be released to bring the data path up.

I will revisit the rules to check exactly what was blocking this particular traffic. 

 

many thanks once again,

 

regards,

JA

484
Views
0
Helpful
3
Replies
CreatePlease to create content