Work Group bridge will only support 8 clients on the ethernet side
Work Group bridge can not perform the role of a repeater.
The Cisco Aironet Workgroup Bridge (hereafter referred to as the bridge) is a small, stand-alone unit that provides a wireless infrastructure connection for Ethernet-enabled devices. Figure 1 on page 1-5 shows a typical network configuration. A device connected to a bridge communicates with a network infrastructure through a Cisco Aironet Access Point (hereafter referred to as an access point). The bridge connects to a device through a standard Ethernet port using a 10BASE-T/RJ-45 (twisted pair) connector. The bridge provides wireless LAN connections for up to eight devices connected to a hub through an Ethernet cable
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...