Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless router not giving out the proper DHCP lease

I have recently installed Aironet 1131 AG wireless routers.

I want the router to give out DHCP leases. I have the FA0 on the 110. I have the dot11 on a 120 network. I set up the router to give out leases on the 120 but it keeps giving them on the 110. What am I doing wrong? Thanks.

2 REPLIES
New Member

Re: Wireless router not giving out the proper DHCP lease

Do you have the correct ip-helper address in place? Can you post your router config.

HTH,

hieu

Green

Re: Wireless router not giving out the proper DHCP lease

Even though all of the VLANs are on one device, they are logically separate.

The AP / system will only provide DHCP services on the native VLAN.

To get the addresses to other VLANs, you must also have some kind of Layer 3 device (router / L3 Switch), and an "IP Helper" address set up on the inbound (client side) interface for that VLAN.

So, if you had a router connected and set up for 802.1q trunking, and two logical interfaces fa0/0.110 and fa0/0.120 (110 being the native or management VLAN), you need to go to the fa0/0.120 interface and add "IP HELPER

"

HTH

Good Luck

Scott

369
Views
0
Helpful
2
Replies
CreatePlease login to create content