09-09-2010 02:32 PM - edited 07-03-2021 07:09 PM
I have a Cisco Wireless Router, Model # WRT160N. I had initally installed it to a laptop. I have a new PC which I am trying to install it to. Unfortunately, when I installed it to the laptop, I put in a new Username and Password. When I tried to install it to the PC, it gets to point of trying to read the router and then gives me the error message "Needs Factory installed Username and Password". I went to the IP site and tried to see where I could delete my Username and Password and reinstall the Factory defaults but cannot locate it. Any suggestions?
Randy McMahon
09-10-2010 10:35 AM
Hi Randy,
Did you see this doc?
Cheers!
Rob
09-25-2011 11:00 AM
Hello Randy,
Please mark the Question as Answered, if the provided information by Rob is correct and it helped. By doing that others can take benefit as well.
Thanks,
Vinay Sharma
Community Manager – Wireless
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: