Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless Upgrade with FlexConnect APs and no HA

Hi all,

I am planning an upgrade of a 5508 WLC with all APs in FlexConnect mode.  The APs do not have a primary, secondary, or tertiary controller configured under the High Availability tab per AP.  I know APs should join the controller to which they were previously associated upon a reboot, but does this still hold true once the AP software is upgraded as well?

 

Thanks in advance for your replies!

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi,Yes..Basically they should

Hi,

Yes..Basically they should remember the WLCs which they know before the upgrade.

To check about the WLCs which they know ? Use ..."sh capwap client config" on the AP.

 

Regards

Dhiresh

1 REPLY
Cisco Employee

Hi,Yes..Basically they should

Hi,

Yes..Basically they should remember the WLCs which they know before the upgrade.

To check about the WLCs which they know ? Use ..."sh capwap client config" on the AP.

 

Regards

Dhiresh

74
Views
0
Helpful
1
Replies
CreatePlease to create content