Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Wireless VLAN help

We have two wireless devices both with two radios installed. Dot11Radio1 is used for our bridge and the other radio is used for wireless users. My problem is that I have two VLANS, vlan 100 is for data traffic and mgmt traffic, and vlan 200 is for my voice traffic. I can only seem to get VLAN 200 to communicate over this bridge connection based on my output of sho dot11 association. With the attached configuration I cannot ping anything on VLAN 100 on remote bridge, and users at this remote cannot get to the internet.

ap1.hostbridge#sho dot ass 0019.079b.0100

Address : 0019.079b.0100 Name : ap2.remotebridge

IP Address : 192.110.235.119 Interface : Dot11Radio 1

Device : 11a-bridge Software Version : NONE

CCX Version : NONE

State : Assoc Parent : self

SSID : wirelessphones VLAN : 200 <----

Hops to Infra : 1 Association Id : 6

Clients Associated: 0 Repeaters associated: 0

Tunnel Address : 0.0.0.0

Key Mgmt type : NONE Encryption : WEP

Current Rate : 54.0 Capability : WMM

Supported Rates : 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0

Voice Rates : disabled

Signal Strength : -70 dBm Connected for : 778 seconds

Signal to Noise : 28 dBm Activity Timeout : 30 seconds

Power-save : Off Last Activity : 0 seconds ago

Apsd DE AC(s) : NONE

Packets Input : 2086 Packets Output : 2044

Bytes Input : 190223 Bytes Output : 275211

Duplicates Rcvd : 0 Data Retries : 0

Decrypt Failed : 0 RTS Retries : 0

MIC Failed : 0 MIC Missing : 0

Packets Redirected: 0 Redirect Filtered: 0

When I try to add the VLAN 100 SSID under the Dot11Radio1 interface the remote bridge deauthenticates on vlan 200 SSID, and no more connectivity. Also the Virtual interfaces go down down.

I am trying to connect both VLAN 100 and VLAN 200 over this bridge connection, but it doesn't seem to work. What am I missing?????

1 REPLY
Hall of Fame Super Red

Re: Wireless VLAN help

Hi Glen,

I have never done much with bridging so I don't know if this helps :( But I did come across this good doc that discusses the config of Multiple vlans in a bridging environment;

VLANs on Bridges

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml#vlanbr

Hope this helps!

Rob

120
Views
0
Helpful
1
Replies
CreatePlease to create content