Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WISM-1 Error

Hello:

I have a 6506-E Switch that was functioning in VSS Mode. I already clear this configuration and only have one switch with a Service WISM Module.

This is the output show wism status

#sh wism status

Service Vlan : 168, Service IP Subnet : 192.168.1.1/255.255.255.0

      WLAN

Slot  Controller  Service IP       Management IP    SW Version  Status

----+-----------+----------------+----------------+-----------+---------------

4     1           192.168.1.2      172.20.50.10     7.0.98.218  Oper-Up

4     2           0.0.0.0          0.0.0.0                      Service Port Up

sh ip int b | inc Port

Port-channel140        172.20.253.246  YES manual up                    up     

Port-channel407        unassigned      YES unset  up                    up     

Port-channel408        unassigned      YES unset  up                    up 

The led Status on the Second Controller is "ORANGE"

What can be the problem.

I power down the module 4 and it doesn´t work.

The first Controller is working Properly.

What can be the problem??????????

Everyone's tags (4)
5 REPLIES
Hall of Fame Super Gold

WISM-1 Error

4     2           0.0.0.0          0.0.0.0                      Service Port Up

Console into the controller.  There's no IP addresses anywhere.

Silver

WISM-1 Error

a WISM1 has 2 controllers, so you have to configure the second one.

---

Posted by WebUser Erik Boss from Cisco Support Community App

Hall of Fame Super Silver

WISM-1 Error

Just to add.... take a look at this guide as it will explain how to setup your WiSM.  Like Leo and Web User mentioned, there are two separate WLC's in a WiSM1 and you also have to define your service port IP address.

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a00808330a9.shtml

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Re: WISM-1 Error

Not relegated to your issue but I noticed your code is 7.0.98 .. Id recommend a higher code rev. .98 was problematic ..

Sent from Cisco Technical Support iPad App

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________

WISM-1 Error

WISM consists of two independent controllers. Interfaces and ip addresses have to be considered on both cards independently. Use the following command to verify installation of both cards. Orange color of Stat. LEDs signifies booting is in process. Crossing temp threshold can also display orange color.

cat6506#show module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  3   10  Wireless Service Module               WS-SVC-WISM-1-K9   SAD092504J8
  4   48  48-port 10/100 mb RJ45                 WS-X6148-45AF      SAL08154UT3
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     SAL0913827E


Mod  Online Diag Status 
---- -------------------
  3  Pass <>
  4  Pass
  5  Pass 
185
Views
0
Helpful
5
Replies