08-01-2006 09:28 PM - edited 07-04-2021 12:46 PM
Hi,
I was looking in WLC Release 4.0 Command Reference and it is saying the WiSM does not support any DEBUG commands !!!
Is this for real?
How long before it gets them?
See,
http://www.cisco.com/en/US/products/ps6366/products_command_reference_chapter09186a00806b4ca7.html
Regards, MH
08-02-2006 04:35 AM
Hello,
which specific debug commands are you referring to (in the link you posted) ?
The commands:
debug wism wcp {data/errors/headers}
debug wcp {packet /events}
should be available...
Regards,
GNT
08-02-2006 07:24 PM
It doesn't make much difference which DEBUG commands I talk about with WiSm since this link says NONE of them are supported ... ie. there is no DOT for WiSM next to DEBUG commands.
Look at "debug wcp" if you like - It's not supported by WiSM.
What is "debug wism" - it's not in the Command Ref. v4.0.
I agree it should ... but does it?
Regards, MH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide