Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WiSM Controller 2 doesn't get service port IP but Controller 1 does

I followed the cisco documentation for setting up the WiSM. Controller 1 is up and fine.

I see in DHCP bindings that Controller 2 is getting an IP Address and when I "session slot 9 proc 2" it tried to connect to that IP Address

but on a "show wism status" the service port of Controller 2 is 0.0.0.0

Has anyone encountered this problem?


Thanks

3 REPLIES
Cisco Employee

Re: WiSM Controller 2 doesn't get service port IP but Controller

Hi..

What about the connectivity?? do we  still have the access to the WLC 2?? either from telnet or the GUI?? or  will the session to the WLC work?

Regards
Surendra

Community Member

Re: WiSM Controller 2 doesn't get service port IP but Controller

This is a brand new installation so I started with Controller 1 on the WiSM. I can GUI, Session ..etc into that.

I started to set up Controller B and saw the service port had 0.0.0.0 but dhcp bindings show it got an IP Address. I can't session, gui...etc into Controller 2 at all.

Community Member

Re: WiSM Controller 2 doesn't get service port IP but Controller

attached is the show ip dhcp binding and the show wism status

276
Views
0
Helpful
3
Replies
CreatePlease to create content