Has anyone come across this issue where if the 6500 switch is reloaded or power cycled that 8 out of 10 interfaces on the WISM become administratively down this does not happen if you reload just the wism or power cycle the controller.
the softwear loaded on the switch is as follows.
Supervisor Engine 720 10GE with f/w 8.5(2) and s/w 12.2(33)SXH
WiSM WLAN Service Module with f/w 12.2(14r)S5 and s/w 12.2(33)SXH
any suggestions as to how to sort this so it loads all the interfaces as up from the power cycle or reload of the switch would be welcome have already made sure the config is saved but still happens.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...