Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WiSM Custom Internal Auth SSL

Hi,

We're using custom internal auth on our new WiSM and it works great.

The only issue we have is that the self signed certificate prompts warning messages for the user before they can authenticate. We need to avoid this and are looking to get a proper certificate to replace it.

The web page appears to come from the virtual interface - in our case 1.1.1.1

a) is it possible to get a certificate from a certificate authority for this IP address?

b) can the same certificate be used on both controllers within the blade - or will it need two seperate ones?

c) To get a certificate I need to get the CSR to submit, but I can't find it?

Thanks,

Philip

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: WiSM Custom Internal Auth SSL

You need a certificate that is trusted in your cert store. You might try to look at this. RapidSSL is one that I use alot.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00806e367a.shtml

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

Re: WiSM Custom Internal Auth SSL

You need a certificate that is trusted in your cert store. You might try to look at this. RapidSSL is one that I use alot.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00806e367a.shtml

-Scott
*** Please rate helpful posts ***
128
Views
0
Helpful
1
Replies