Since this is for redundancy, all WLC will have to be on the same mobility group. Only if you you have different buildings would you might not want to have then on the same mobility group. For example... if WiSM 1 WLC 1 is primary for building 1 and WiSM 1 WLC 2 is primary for building 2 ,WiSM 2 WLC 1 is secondary for building 1 and WiSM 2 WLC 2 is secondary for building 2. Mobility group for WLC 1 would be building1 and WLC 2 would be building 2. If both WiSM's will be primary or secondary to any of the access points, will the mobility group name have to be the same.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...