WiSM in a Cat6500

[hanwucisco]

we have two wisms in a cat6500, I wonder how can you log into the wism from the switch. to be more specifically, how can I know the processor number?

thanks,

han

[Stephen Rodriguez]

This only will work if you have the Service Port configured porperly.

from the Sup

session slot x proc y.  so if you had a WiSM in slot 4 and wanted to get into the first WLC

session slot 4 proc 1

Steve

[hanwucisco]

Steve,

I tried,

session slot 7 proc 0--9, none of them works. and i pretty sure, it was configured right.

here is show module command, any idea

=====

c6509-w1#sho module

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

  1    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE      SAD10470C9L

  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAD103701FT

  7   10  WiSM WLAN Service Module               WS-SVC-WISM-1-K9   SAD18450A28

  8    6  Firewall Module                        WS-SVC-FWM-1       SAD104702X1

Mod MAC addresses                       Hw    Fw           Sw           Status

--- ---------------------------------- ------ ------------ ------------ -------

  1  0019.aacc.a772 to 0019.aacc.a875   2.4   12.2(14r)S5  12.2(33)SXI5 Ok

  5  0011.9202.7ac0 to 0011.9202.78c3   5.2   8.4(2)       12.2(33)SXI5 Ok

  7  0019.aacc.8254 to 0019.aacc.8863   1.4   12.2(14r)S5  12.2(33)SXI5 Ok

  8  0019.aaf4.ad36 to 0019.aaf4.ad8d   4.1   7.2(1)       4.0(16)      Ok

Mod  Sub-Module                  Model              Serial       Hw     Status

---- --------------------------- ------------------ ----------- ------- -------

  1  Centralized Forwarding Card WS-F6700-CFC       SAD10450BK4  3.0    Ok

  5  Policy Feature Card 3       WS-F6K-PFC3B       SAD102900WV  2.3    Ok

  5  MSFC3 Daughterboard         WS-SUP720          SAD103106H0  2.5    Ok

  7  Centralized Forwarding Card WS-SVC-WISM-1-K9-D SAD10450AED  1.4    Ok

Mod  Online Diag Status

---- -------------------

  1  Pass

  5  Pass

  7  Pass

  8  Pass

[Stephen Rodriguez]

it would have been session slot 7 proc 1 | 2

can you post the output of show wism status

Steve

[weterry]

Perhaps a show wism summary    (or is it status?)               to confirm that the service port and everything up and running fine?

Either way, as Stephen said, basic syntax is: session slot [X] proc [1 or 2]

EDIT: (and now I just read that Stephen also mentioned the making sure the service port is configured correctly)