Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

WISM Stability and Load

We have run wisms for two years with different codes(4.0, 4.1 and 4.2). We have both web auth wlan and WPA wlan(majority of users are on web auth wlan). We have found when wisms are running in a higher load(500-1000 users per controller), they will start to have crash issue and web auth issue(web login page not loading). They run very stable when the load is low.

Is this the same case for other deployments as well? I hope someone can share following info with me:

1. Are your wisms stable and what code do you use?

2. How many users total and how many web auth users do you have per controller(NOT per wism blade)

Thanks!

2 REPLIES
Silver

Re: WISM Stability and Load

CSCsf26567 - memory leaks caused by EAPOL packets

CSCsf27479 - WiSM locks up and does not generate crash file after

reboot.

filter non used vlans on the trunk port going to the controller(switchport trunk allowed vlan) command. This does not fix the

issue, but lowers the frequency.

Bronze

Re: WISM Stability and Load

I have already filtered the non used vlans on the port channel and we still see the crash and web login issues from time to time when we have more than 500 web auth users per WLC. It seems WLCs have lots of issues with webauth. If not using webauth, they are stable.

144
Views
0
Helpful
2
Replies
CreatePlease login to create content