Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wism version 2 support feature "enable NAT address?

hi all

i would like to ask some question that wism v 2 support feature nat address? because i see in configuration guide it just tell about wlc 5508. So, please give me or share information.

Thanks.

Everyone's tags (7)
7 REPLIES
Hall of Fame Super Silver

Re: wism version 2 support feature "enable NAT address?

That is a setting for OfficeExtend AP's when the APs use the public address to join the WLC.

http://www.cisco.com/en/US/products/ps11579/products_tech_note09186a0080b7f10e.shtml

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Re: wism version 2 support feature "enable NAT address?

It is only for 5508 controllers.

It is mentioned n the config guide:

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_ports_interfaces.html

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
Hall of Fame Super Silver

wism version 2 support feature "enable NAT address?

This feature is also on the 2504, Flex7500 & wism2.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

wism version 2 support feature "enable NAT address?

I'll reach out to the guys in TAC and get there thoughts on this.  It could be a documentation bug, or it could be an interpretation issue.  That does say only for dynamic AP managers, but should be available on all managmenet interfaces.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Hall of Fame Super Silver

wism version 2 support feature "enable NAT address?

Thanks Steve (nice to still have contacts on the inside)... I only use it on the managment when deploying OfficeExtend AP's.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Re: wism version 2 support feature "enable NAT address?

That's what the feature is for, the OEAP. and it should be on the management interface, but I'd for some reason you break off the ap-manager it would need to be there. So I would think ti should be configurable in all WLC that support OEAP.

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Hall of Fame Super Silver

wism version 2 support feature "enable NAT address?

Well that is the thing... will it work if you are using multiple ap managers?  What I was told is that the ap's still need to communicate with the management interface with the 2504, 5508... the newer stuff.  Its not like the 4400's where if you break up the management and the ap manager, you can actually isolate the ap manager on a vlan with the aps and the aps will communicate with the ap manager interface only.  The newer controllers don't function like that.  We had a client that migrated  and wanted to keep everything the same.... well it didn't work.  We had to enable routing between the ap manager subnet and the management.  I never split them apart and don't know why people do

Maybe we can get George to test it out

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
567
Views
0
Helpful
7
Replies
CreatePlease to create content