Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WiSM Virtualization

Hello

I ahve 2 Cisco Wism installed on 6506-E running virtualization. when I run show wism status, the controllers are unable to get IP addresses for the service and mangt interface knowing the Vlan is there and local dhcp configured. wism service command is also applied.

wism switch1 module 4 controller 1 allowed vlan is also applied all port are up including virutal port-channel and actual virtual ports that I am unable to configure

any suggestions?

1 REPLY
Hall of Fame Super Gold

Re: WiSM Virtualization

Integrate Cisco Service Modules with Cisco Catalyst 6500 Virtual Switching System 1440

http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml#wism

Cisco WiSM in a Cisco Virtual Switching System Environment

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a0080a6c202.shtml

312
Views
0
Helpful
1
Replies