WiSM2 status keepalive

[mlieber]

we have installed new WiSM2 in Cat6500 and both WiSM are in status "started keepalive".

DESTGSW001#sh wism status

Service Vlan : 192, Service IP Subnet : 192.168.250.65/255.255.255.248

      WLAN

Slot  Controller  Service IP       Management IP    SW Version    Controller Type    Status

----+-----------+----------------+----------------+------------+------------------+---------------

1     1           192.168.250.67   0.0.0.0                       WS-SVC-WISM-2-K9   Started KeepAlive

But everything else looks fine,

Access Points are joined, client are connected and HA redundancy is also working fine.

The WiSM service-ports gets the IP address from DHCP server

The WiSM2 has software

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 7.5.102.0

Bootloader Version............................... 1.0.16

Field Recovery Image Version..................... 7.0.112.21

Firmware Version................................. FPGA 1.7, Env 0.0, USB console 2.2

Build Type....................................... DATA + WPS

and Cat6500

Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICESK9-M), Version 15.1(1)SY1, RELEASE SOFTWARE (fc5)

Does have anyone any idea?

thanks

Martin

[Leo Laohoo]

If your output is correct, your WiSM does NOT have any Management IP Address.

[mlieber]

Hi,

the output is correct.

The management IP address will be visible when the status is "Oper-UP".

[mlieber]

Hi,

this is the output from WiSM

Interface Name                   Port Vlan Id  IP Address      Type    Ap Mgr Guest

-------------------------------- ---- -------- --------------- ------- ------ -----

management                       LAG  300      10.78.200.4     Static  Yes    No

redundancy-management            LAG  300      10.78.200.6     Static  No     No

redundancy-port                  -    untagged 169.254.198.6   Static  No     No

service-port                     N/A  N/A      192.168.250.67  DHCP    No     No

[Johan Lindstrand]

Check your cat6500 konfig.

Maybe something is wrong with this commands:

wism service-vlan xxx

wism switch 1 module 1 controller 1 allowed-vlan 10-1001,1006-4030,4040

wism switch 1 module 1 controller 1 native-vlan 4021

wism switch 1 module 1 controller 1 qos vlan-based

[mlieber]

We have done a hardware reset of the WiSM2, and now the stsuts is "Oper-UP" again.

It looks like the very old bug CSCsg59144