I use this! Locust is a wireless receiver designed specifically for sweeping and optimizing 2.4 GHz Local Area Networks. The instrument measures coverage of direct sequence CDMA networks which operate on the IEEE 802.11b standard allowing the user to determine the AP (Access Point), PER (Packet Error Rate), and RSSI signal levels aiding in locating the hub and access points of neighboring WLANs. Locust provides measurements in realtime and also logs data for further post processing analysis. Users may detect and differentiate from narrowband multipath interferences using a drive-test vehicle, GPS antenna and a laptop PC.http://www.bvsystems.com/Products/WLAN/Locust/locust.htm
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...