when i try to assocate the dhcp scope to wireless.guest.data interface using 192.168.255.1 which is the ip of the that interface it will not let me. I would have thought since i was using the interal dhcp that the .1 address would be the dhcp scope address also. i can assign 192.168.255.0 or 192.168.255.2(gateway)if i use .0 or .2 the dhcp request (discovery) process starts and then will forward to .2 (gateway) and never assign an address. the only thing that happens is that the client wireless interface will get 255.255.255.255 for a few seconds then go away.
what i am trying to accomplish is to connect the wlc port 2 directly to a pix 506 which goes to the internet so the guest traffice is not on our vlan.
any other suggestions on guest vlans would be appricated....
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...