cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
801
Views
3
Helpful
1
Replies

WLC 2112 with LAP 1042N

Hi Guys.

we are trying to configure WLC 2112 with LAP 1042 but getting following erros on LAP1042.

It show the Ap is not supported in controller version 6.0.199.4

*Jan  5 16:52:13.397: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_ip: 192.168.2.101 peer_port: 5246
*Jan  5 16:52:13.398: %CAPWAP-5-SENDJOIN: sending Join Request to 192.168.2.101
*Jan  5 16:52:13.399: %CAPWAP-5-CHANGED: CAPWAP changed state to JOIN
*Jan  5 16:52:13.410: %CAPWAP-3-ERRORLOG: This AP is not supported in controller version 6.0.199.4
*Jan  5 16:52:13.495: %CAPWAP-5-CHANGED: CAPWAP changed state to CFG
*Jan  5 16:52:13.496: %DTLS-5-SEND_ALERT: Send FATAL : Close notify Alert to 192.168.2.101:5246
*Jan  5 16:52:13.497: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jan  5 16:52:13.498: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jan  5 16:52:19.552: %CAPWAP-3-ERRORLOG: Dropping dtls packet since session is not established.
*Jan  5 16:52:29.551: %CAPWAP-3-ERRORLOG: Go join a capwap controller

WLC 2112 software version 6.0.199.4

LAP 1042 image version 7.0.94.21

If any one can help me out then it wolud be great.

Thanks in advance for all.

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

You should upgrade your controller to 7.0.116.0 or 7.0.220.0

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Review Cisco Networking products for a $25 gift card