Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC 4400 Cannot send an ARP reply

Has anybody seen this error message. "dtlArpRequest: Cannot send an ARP reply to 00:0B:85:86:4D:20" It happens when I change the WLC to lag. It works fine without lag turned on. There is about 17 aps on it. As soon as I turn it on and reboot the WLC about 10 of the aps come up. Over time the aps get fewer and fewer until there is 0 aps. Any ideas?? I have checked the switch config per cisco specs and I still have same problem. I have upgraded to 4.0.206 to 4.1.

  • Other Wireless - Mobility Subjects
2 REPLIES
Cisco Employee

Re: WLC 4400 Cannot send an ARP reply

Hi Friend,

I believe you might have reloaded the controller once after you enabled LAG? Also what is the channel-group mode set to on switch side?

Also can you paste the output of "sh interface sum" from controller?

Regards,

Ankur

New Member

Re: WLC 4400 Cannot send an ARP reply

I reloaded it multiple times. Channel-group mode is on. I actually can not because lag is turned off now. I can only do it when I take it down. Thanks for the response.

159
Views
0
Helpful
2
Replies
This widget could not be displayed.