Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC-4402 and AIR-LAP1252AG-A-K9

Hello,

I have a current setup of two WLC-4402's and about 50 AIR-LAP1242AG-A-K9 AP's, recently we purchased a 1252 for testing, how can I incorporate this into our network and test 802.11n, all clients that support n are still connecting to this ap using g...

Any feedback would be appreciated.

Regards,

Luke

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Configure 802.11n on the 5ghz radio. You have to make sure you set the channel (149 for 40mhz above or 136 for 40mhz below just for testing) and power setting of the ap first. Then set the channel width to 40mhz above or below. On the wlan, make sure you have wmm enabled. This is all you need. Hope you get it working.

-Scott
*** Please rate helpful posts ***
8 REPLIES
New Member

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Any help with this problem?

Thanks.

Hall of Fame Super Silver

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Configure 802.11n on the 5ghz radio. You have to make sure you set the channel (149 for 40mhz above or 136 for 40mhz below just for testing) and power setting of the ap first. Then set the channel width to 40mhz above or below. On the wlan, make sure you have wmm enabled. This is all you need. Hope you get it working.

-Scott
*** Please rate helpful posts ***
New Member

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Where do I find the 5ghz settings on the wlc, I cannot see this anywhere, usual settings in wireless-radios-802.11b/g/n..

Thanks

Hall of Fame Super Silver

Re: WLC-4402 and AIR-LAP1252AG-A-K9

It should be under Wireless-802.11a/n-Network.

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Or on the cli....

config 802.11a enable

config 802.11b enable

config 802.11b 11gsupport enable

-Scott
*** Please rate helpful posts ***
New Member

Re: WLC-4402 and AIR-LAP1252AG-A-K9

All this is complete, still can't see the test unit connecting at 802.11n, or higher then 54Mbps.

I've tried disabling 802.11g, forcing the client to connect at 802.11a, no change.

New Member

Re: WLC-4402 and AIR-LAP1252AG-A-K9

Working now, forgot to enable wmm.

Thanks everyone.

Hall of Fame Super Silver

Re: WLC-4402 and AIR-LAP1252AG-A-K9

If you have the 5ghz radio set at 40mhz channel width and wmm enabled, then you have to look at the device configuration. I have a linksys 600N that I'm able to connect to as long as those settings are in place.

Also verify that 802.11n (5GHz) High Throughput is enabled, which it should be by default.

Post your show run-config.

-Scott
*** Please rate helpful posts ***
550
Views
0
Helpful
8
Replies
CreatePlease to create content