Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 4404 4.2.112.0 alarm LED

Can anyone please tell me the reason for the alarm LED being on constantly red?

I have checked cisco documentation but it says it is software dependant. I am running version 4.2.112.0 on the controller, I also have 6 other controllers runinng the same software with no problems and I can't see any difference between them.

5 REPLIES

Re: WLC 4404 4.2.112.0 alarm LED

Have you checked the status of your sfp ports? This is usually an indicator of a port down. If you are using LAG you might not notice it down.

New Member

Re: WLC 4404 4.2.112.0 alarm LED

Thanks for the reply. I have checked the controller and all four ports are up.

Re: WLC 4404 4.2.112.0 alarm LED

How about temperature and fan status?

New Member

Re: WLC 4404 4.2.112.0 alarm LED

I have done a show sysinfo from the command line and it shows that both PSU's are up and the fans are running fine, it also shows that the temperature is 42oC which is well within the operating alram limit. This is really frustrating as I can't see any differences between the controllers, I am beginning to think that this may be either a faulty LED or there is something else fundamentally wrong with the hardware. I think this may have to be RMA'd. The reason I posted the question in the first place is that the cisco website says that the LED is software dependant but then it doesn't give any info for the individual software releases.

Thanks for replying again

Re: WLC 4404 4.2.112.0 alarm LED

I think you're right. I'd call TAC and see about an RMA. I'm picky about my alert LEDs working right. :) This would drive me nuts!

162
Views
5
Helpful
5
Replies