Having installed a WLC 526 for a small school I have assumed that the ports were similar to those on the 2100 etc. However whenever port 2 is cabled the WLC dies.
The setup is a flat layer 2 domain WLC with 5 aps connected. All connected via a linksys switch. No VLANs so no tagging. Everything works fine via port 1, ap-manager and managemnet set to port 1 but as soon as port 2 connected it all sits down and the aps disconnect. I am thinking its something I am overlooking?
What were you going to use port 2 for? It can't be LAGGED as this unit only support 100mb throughput. The 526 doesn't support redundant connections either via a code switch. The 526, even though LWAPP, does not have all the features of the full blown Enterprise LWAPP controllers.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...