Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

wlc anchor aaa override with 802.1x

I have a 4402 WLC to act as an anchor controller in a DMZ enviroment.

My wireless clients associate with several WiSM's in the local network.

I would like to create a WLAN that uses 802.1x (WPA2) to authenticate the clients and then bind them to the anchor controller in the DMZ.

But I notice that the 802.1x part is being handled by the foreign controllers (WiSM's) and not by the anchor controller. So I cannot use the AAA override to assign different DMZ vlan's with my radius reply.

Is this correct ?

Thanks,

Gerard van Bon

2 REPLIES
Hall of Fame Super Silver

Re: wlc anchor aaa override with 802.1x

i don't think you can do that. you can put a client on a certain vlan, but since you are creating a mobility anchor to a 4402 in the DMZ, no way to push them to a WLC.

-Scott
*** Please rate helpful posts ***
New Member

Re: wlc anchor aaa override with 802.1x

Thanks,

I now also think that it is not possible.

360
Views
0
Helpful
2
Replies
CreatePlease to create content