Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

WLC AP Power Levels

I used AirMagnet Planner to place 1242 APs in warehouse using 35mW and -65 dBm cell edges with 20% overlap for 7921G phones.

I plan to use RRM and Dynamic Power Levels. However I noticed when manually setting the power I can choose, 1 thru 5. With 2 50% and 3 being 25%.

Will Dynamic Power Management set AP levels between 25-50%?

3 REPLIES
New Member

Re: WLC AP Power Levels

RRM uses signal strength information from neighbouting APs and assosciated clients to assign a power level, to adjust the behaviour you will need to tweek the RRM sensitivity.

Hope this helps

Re: WLC AP Power Levels

Is the AP Power Level in "dynamic" varying between 25mW and 50mW, say 35mW? Or will it use exactly 6.25, 12.5, 25, 50, 100 for all AP power outputs?

Re: WLC AP Power Levels

The default power setting is “Automatic” (uses Radio Resource Management) which I understand is variable but is not documented in the WLC administration guide

723
Views
0
Helpful
3
Replies
CreatePlease login to create content