the attached design for WLAN , there are two buildings one is the faculty of computer science where the access points and the distribution layer switch are resides, the second building is the IT management building where the core layer switch reside, the connectivity between the core and distribution is using the layer 3 connectivity (EIGRP routing), the VLANs are created on the distribution layer switch, and multiple VLANS needed to be configured on the WLC, i am thinking to use flexconnect or REAP and DHCP 43 , but after registration how i can configure the different VLANS with different subnet ?
shall i configure the vlan interfaces on the distribution layer switch with ip addresses and assign it as agateway for AP? if some one can help.
You can take advantages of Local mode AP deployment, if you could move your WLC onto your distribution layer (in your case computer science building).
If you go ahead with FlexConnect mode, then you do not require to define dynamic interface on WLC with the same subnet as users IP range. You can have a dummy interface in WLC, but WLAN configured for FlexConnect Local Switching. In this way users will get IP as per the SVI configuration on your distribution layer.
Compare to Local mode, FlexConnect mode having certain deployment limitations (no multicast, no L3 roaming, No of AP in a FlexConnect group, etc)
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...