WLC b/g power setting

[mprofitt1967]

Does the 4402 WLC allow individual tx power control over cck and ofdm in the b/g radio? If so, what is the command line and if not, where is this documented?

[Scott Fella]

There is not a way to control power between b & G, since G is backwards compatible. Why would you want to do this?

[mprofitt1967]

There is no reason to do this, just curiosity.

In a 1242 you can control the power levels of CCK and OFDM with the following commands?

#interface dot11radio 0

#power local cck {dbm}

#power local ofdm {dbm}

Why not in lightweight mode?

Thanks

[dennischolmes]

The lightweight mode has very limited CCK control on an individual AP basis. All control is based on the controllers configuration.