Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC b/g power setting

Does the 4402 WLC allow individual tx power control over cck and ofdm in the b/g radio? If so, what is the command line and if not, where is this documented?

3 REPLIES
Hall of Fame Super Silver

Re: WLC b/g power setting

There is not a way to control power between b & G, since G is backwards compatible. Why would you want to do this?

-Scott
*** Please rate helpful posts ***
New Member

Re: WLC b/g power setting

There is no reason to do this, just curiosity.

In a 1242 you can control the power levels of CCK and OFDM with the following commands?

#interface dot11radio 0

#power local cck {dbm}

#power local ofdm {dbm}

Why not in lightweight mode?

Thanks

Re: WLC b/g power setting

The lightweight mode has very limited CCK control on an individual AP basis. All control is based on the controllers configuration.

181
Views
0
Helpful
3
Replies
CreatePlease login to create content