11-09-2011 10:24 PM - edited 07-03-2021 09:03 PM
Hi,
Regarding the subject, anyone can enlighten me which one is better for setting the channel assignment of Lightweight on WLC?
Does it better to use "Auto" or manually setting the channel/power on each individual AP.
Thanks,
Solved! Go to Solution.
11-10-2011 02:20 AM
It is better to have the wlc choose the channels. RRM has come a long ways and I believe it works better now than it first did when it was first was an option.
Sent from my iPhone
11-10-2011 02:56 AM
Well, just monitor it for a while. Here is a good doc that explains RRM pretty good.
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072c759.shtml
Sent from my iPhone
11-10-2011 02:20 AM
It is better to have the wlc choose the channels. RRM has come a long ways and I believe it works better now than it first did when it was first was an option.
Sent from my iPhone
11-10-2011 02:42 AM
Thanks Scott.
Wondering about the accuracy of WLC's auto settings.
I observe two adjacent APs got a same channel and power assignment from the Controller. I am worry about interference caused by channel overlapping.
Sent from Cisco Technical Support iPhone App
11-10-2011 02:56 AM
Well, just monitor it for a while. Here is a good doc that explains RRM pretty good.
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072c759.shtml
Sent from my iPhone
11-10-2011 06:49 AM
Thanks again Scott,
A very valuable doc.
Sent from Cisco Technical Support iPhone App
11-10-2011 06:57 AM
No problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide