Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

WLC compatibility anWireless card RALINK 2561 T on a light Pc (NEC TCM 160)

Hello i have strange roaming conditions with a NEC light Pc (no hard drive, flash card and windows XP embedded) and an integrated wireles card RALINK 2561 chipset.

I have put latests drivers for XP on xp embbeded NEC pc.

WLC are 2 WiSM in version 3.2.116

Access points are 1131LAP

My case is : a corridor with 2 LAP

i bootup the NEC-PC and associate to the right AP (nearest AP)

I walk along the corridor, and when i am under the second AP, i am still attached to the first AP, so i keep on walking and i stay associated to the first one with some lost ping and very bad times (1 to 2.5 seconds for exemple)

In order to roam i have to walk and go outside the corridor where i don't see anymore the first AP in order to roam to the second AP.

That's quite strange becaus with a "normal Windows XP" i roam 2 or 3 meters before i walk under the second AP.

I will try to upgrade controller but i think the trouble is more in drivers or windows XP embedded;

I use Windows zero config in both cases (xpe or xp pro).

Does anybody have seen this with this card ? with windows XP Embedded ?

Thanks for your help.

1 REPLY

Re: WLC compatibility anWireless card RALINK 2561 T on a light P

Upgraded to 3.2.195.10

same trouble with roaming and windows XP embedded wifi client

With ralink client and parameter "fast roaming" set at -60dbm => roaming is better.

but without ralink wifi client : not working better.

GB

365
Views
0
Helpful
1
Replies