I have a WLC 4000 series and 10 APs 1200, the WLC is running in Layer3 mode, a get that all APs registered in the WLC, i running a DHCP server on the WLC all APs are getting addresses from the WLC but i don't get any address in the clients from any of those APs.
Alos make sure you have configured the dynamic interface for the subnet the clients will be on and that you have mapped that under the wlan ssid. On the dynamic interface, make sure you specify the management IP Address under primary DHCP and that on the wlan ssid, the dhcp override check box is not checked.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...