I want to deploy two wlc 5508 running Software Version 184.108.40.206 in failover mode.
I read the documentation and I read that the two wlc must have the same configuration.
I want to be sure that I've well understood.
For all the interfaces, each appliance must have a different IP. I mean if WLC1 have the interface "ap-manager" "management" and "dynamic interfaces" in .1, I suppose that WLC2 should have the same interfaces with .2 IP.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...