Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC gui

I have a WLC 2112 working fine with several WLANs and interfaces. the ap-management and management interface are in the same vlan.

I found a problem, the gui admin only works if my browser is in the same vlan as the ap-management and management interface.

the http and https is opened in the firewall. Any ideas what I need to do?.

Thanks.

1 REPLY

Re: WLC gui

Rafael,

     This is expected behavior.  The WLC does not answer if you are on the same subnet as a dynamic interface, by default.  You can issue the command   config network mgmt-via-dynamic-interface enable, to allow this.

     Now, if you're saying that you can't access the WLC from another VLAN that is not also a dynamic interface, I would check teh gateway to make sure it/they have routes to appropriate networks.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
229
Views
0
Helpful
1
Replies