Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WLC - Manual AP Failback

Hi,

I have disabled automatic failback as I would like to failback in a controlled manner should the primary WLC fail. However, is there a "nice" way to do this without either rebooting the AP's or rebooting the secondary WLC?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: WLC - Manual AP Failback

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

2 REPLIES
Gold

Re: WLC - Manual AP Failback

You could reboot either device like you mentioned or you could just re-enabled AP fallback temporarily.

Community Member

Re: WLC - Manual AP Failback

Thanks - Good point about re-enabling the AP fallback for a short period. Much nicer than rebooting things.

Thanks for your help

262
Views
0
Helpful
2
Replies
CreatePlease to create content