I have several controllers at remote sites that I cannot push WLAN templates to. I am running Contivity routers. Whenever I attempt to send the template it fails but does not give me a reason. Does anyone the ports the WLC using to send templates. The WLC was able to discover them fine. It just seems to be an issue of sending the templates.
Can you do a "save config to flash" to the same controllers successfully? If you then do a refresh config from controllers" with delete is that successful?
If the save is successful and the refresh is not I'd say and issue with mtu over the vpn maybe. Check to to see how many varbinds you are sending under Administration > Settings > SNMP Settings. If it is greater than 50 change to 50 and save then try the test again.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...