I have one WCS running 184.108.40.206. Currently there are few WLC's(inturn supporting Cisco 1010 AP's) associated with it which are running 220.127.116.11 and 18.104.22.168. I have one more WLC which is running 22.214.171.124 which is not getting added in WCS. I came to know the reason was WCS is running one revision older firmware. The solution is to upgrade WCS to 4.0 or 5.0, but if i upgrade the same then will WCS support the existing WLC's running 3.2.X.X ? Also if i degrade the 126.96.36.199 WLC to 3.2 then will there be any impact to the connected AP's (Cisco 1010 and 1242AG both running on 188.8.131.52. Please let me know the best solution so that all my WLC's get added to WCS successfully.
the difference was during the time of installation by some other person. Currently Each WLC is placed at different geogrophical location. So you mean i can upgrade WCS to 4.X and still it will support 3.2.X.X WLC's?
the difference was during the time of installation by some other person. Currently Each WLC is placed at different geogrophical location. So you mean i can upgrade WCS to 4.X and still it will support 3.2.X.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...