Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC4402 - No keyboard input via console

Hello,

I try to configure a WLC4402 new out of the box. If I make a console connection for initial configuration I see the boot sequence in my terminal software but I am not able to send keyboard commands. the session does not accept keyboard input. I tried to do this with different PC's, different serial ports and different cables, including the supplied console cable. I have been testing with other devices (cisco router on console cable) and with these devices everything works fine. Only the WLC4402 gives me trouble. Any advice? Thank you.

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: WLC4402 - No keyboard input via console

Make sure that flow control is disabled on your terminal emulation program.  Having flow control enabled will cause the exact issue you are describing.

2 REPLIES
Gold

Re: WLC4402 - No keyboard input via console

Make sure that flow control is disabled on your terminal emulation program.  Having flow control enabled will cause the exact issue you are describing.

New Member

Re: WLC4402 - No keyboard input via console

That is the solution. Thank you.

2955
Views
5
Helpful
2
Replies