Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC4404

I have serveral WLC4404 configured in a Mobility Group. Is there any way to reduce the time it takes to roam between them ?

1 REPLY
Hall of Fame Super Silver

Re: WLC4404

Try to setup the access points on the same controller to prevent too much inner controller roaming. For example.... if you have 2 4404-100 and you have a max 100 ap's, what you can do is either have all the ap's on WLC1 and use WLC2 as a backup. Another way is to separate the ap's to WLC by floor. Floor 1-3 on WLC1 and floor 4-6 on WLC2. The roaming should be fast anyways, but as long you try to keep the user on a certain WLC then you wouldn't have to worry about the roaming between WLC's. Hope this makes sense.

-Scott
*** Please rate helpful posts ***
136
Views
0
Helpful
1
Replies
CreatePlease to create content