I would like to install a connection with root and a workgroup access point. On the site of the workgroup bridge access point I have an other switch where I need 3 different vlan. Is it possible to configure different vlan over this connection or can I just use one vlan on the site of the workgroup bridge.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...