I am trying to setup an 1131AG (version 12.4.10b-JA) in Workgroup Bridge mode to connect to my wireless network, which is a Light Weight network (WCS version 126.96.36.199 and WLC version 188.8.131.52, the APs are 1131AGs in LWAPP mode). I am using LEAP for authentication. So far I've been pretty unsuccessful. The three popular error messages I seem to get depending on how I fiddle with things are:
Benjamin, did you ever figure this out? I am dealing with the same problem right now using a 1231 autonomous AP as WGB. I'd actually like to configure it for EAP-FAST as opposed to LEAP, but can't find documentation that covers EAP-FAST. Only EAP-TLS.
Yes, I finally figured it out and it was the dumbest thing. The person before me who had configured our WLANs on the WLC disabled Aironet Extensions in the WLAN profiles. Apparently Cisco WGB can't connect without that being on... can't believe I over looked it, but glad I got it fixed.
The config I posted I believe is actually fine and you might be able to look at it and figure out what you need to modify to get EAP-FAST to work.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...