Workgroup Bridge with PEAP

[Dominic Stalder (old profile)]

Hi there

we would like to configure a WLAN Workgroup Bridge with an aironet 1140 and PEAP, is this possible. Here is the actual configuration.

dot11 ssid air-secure-7

   authentication open eap eap_methods

   authentication network-eap eap_methods

   authentication key-management wpa version 1

   authentication client username xxx password 7 xxx

!

power inline negotiation prestandard source

!

!

!

bridge irb

!

!

interface Dot11Radio0

no ip address

no ip route-cache

!

encryption mode ciphers tkip

!

ssid air-secure-7

!

station-role workgroup-bridge

bridge-group 1

bridge-group 1 spanning-disabled

!

Regards

Dominic

[Surendra BG · Accepted solution]

PEAP for WGB not supported..

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml#conf

Regards

Surendra

[Dominic Stalder (old profile)]

Hi Surendra

thanks a lot for your quick answer, this is what the Cisco Partner Helpline told me:

Thank you for contacting Worldwide Partner Helpline. My name is Marie and I will be assisting you with this case.

To answer your inquiry, yes, it is possible to configure a workgroup bridge with PEAP authentication. Kindly refer to the documentation using the link below.

PEAP under Unified Wireless Networks with ACS 4.0 and Windows 2003:
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00807917aa.shtml

But now I now for sure.

Regards

Dominic