Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WPA and Cisco 350 PCI

This is pretty hard to believe, I have an Aironet 1100 wireless network setup, I recently upgraded to 12.2(13) firmware and am using WPA with a pre-shared key and WEP128+TKIP.

I can connect to the WAP's no problem with Dell D600 laptops with built in DELL cards, but none of my 350 clients can connect.

I have upgraded them to V5.30.17 firmware and installed the 815485 windows XP patch.

Truly amazed that a Cisco card can't connect to a CISCO WAP...must be missing something here...

2 REPLIES
New Member

Re: WPA and Cisco 350 PCI

The cipher used for WPA has to be TKIP only. I ran into a similar issue when trying to use WEP128+TKIP.

However, I only have Cisco 350 adapters however so I am not too familiar on how to make this interoperate with Dell. Are your Dell machines using WPA successfully with your current config?

New Member

Re: WPA and Cisco 350 PCI

I have upgraded my AP 1230 to 12.2(13)JA3 and I see no problems wit my 350 clients. Everything is working fine.

So something messed up your configuration I would not blame Cisco yet.

223
Views
0
Helpful
2
Replies
CreatePlease to create content